Customer Service

Shipping & Ordering Info.

Privacy & Security


Customer Testimonials




Sicce Wave Surfer Pump Controller (Item Currently Unavailable)

Sicce Wave Surfer Pump Controller (Item Currently Unavailable)
Item Code: ROYASCSIC322

The new Wave Surfer from Sicce is designed to simulate marine reef currents in the home aquarium. Easy to program, it has been designed to offer numerous features without complicated computers or power controllers. When used with aquarium pumps, the Wave Surfer allows the creation of multiple currents from different directions within the tank. Its controls make it simple to regulate the timing of the pumps connected to it. Customization is possible by setting switching intervals, Feeding Mode, and Night Mode, depending on needs of the ecosystem being created. How long pumps stay turned off during the feeding of the aquariums inhabitants and how much water movement is reduced during night cycles are controlled by these settings. The Wave Surfer is the perfect compliment to SICCE Voyager and Syncra pumps, but it can also be used with any make of recirculation or stream pumps, up to a total of 100 watts for the two outlets.

Technical Data
For best results, pair the unit with SICCE Voyager stream pumps. In all other cases, do not attach devices with power higher than 100W – 1.5 Amp to the power sockets on top of the unit.

1. Connect each pump to one of Wave Surfer’s power sockets
2. Make sure the left knob (F) is on “off” position
3. Connect the device to the power unit
4. Turn the left knob (F) to adjust length of a complete cycle (e.g. 20 sec = 10 sec ON + 10 sec OFF)
5. Turn the right knob (G) to adjust the rate of distribution on each channel (see table below)
Extra Functions:

Feeding Mode (-CLIC-)
This special function is useful for the administration of food or medicine to the aquarium’s inhabitants: with one fast “CLIC” of button (H), both channels P1 and P2 (including the 2 LED lights) will deactivate for 4 Minutes, in order to stabilize water movement and allow adequate time for organisms such as invertebrates, to feed. This function can be
manually deactivated by clicking the button. This function can be personalised as described below:

1. Press Fish Food button down for 7 seconds, until P1 and P2 indicator LED lights blink simultaneously
2. Adjust left knob (F) on desired time
3. CLIC on the same button to confirm settings
Night Mode (2 Sec. Press)

This function reduces water movement for 8 hours overnight. Applying pressure for 2 Seconds on the practical
button (H) deactivates the cycling of pump 2 for 8 Hours (fixed amount of time, non customizable). Afterwards,
pump 2 will resume regular cycling. When this function is active, LED (C) will blink slowly. To manually deactivate
this function, simply click the same button.

Note: this function only works if two pumps are connected.

Quantity : 

$CAD 139.99 - $CAD 119.99